Subject: Oil Filler Tube Removal (Was New Manifold)
From: ACRE NL
Date: 7/4/2001, 5:09 PM


Paul,

    I have removed the oil filler tube from two engines.  You do not need
to
cut it off and in fact removing it intact may save some grinding work.
The
oil filler tube is pressed into the hole in the center housing.  I have
found that taking a large wench and hammer I can tap and twist on the oil
fitting tube and once broken loose it can be removed intact.  FWIW

Ed Anderson

Thanks Ed. Perhaps a bit of heat on the casting would also help.

Paul Lamar EGOOSP

George Lendich wrote:

Paul,
I'd be more inclined to just weld a bit on, to make it longer, if I were to
 run it through the plenum.
George (down under)

That would work too depending on how the plenmum was attached
to the manifold.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org