Subject: Oil Filler Tube Removal (Was New Manifold)
From: ACRE NL
Date: 7/4/2001, 9:13 PM



Paul,
I'd be more inclined to just weld a bit on, to make it longer, if I were to
 run it through the plenum.
George (down under)

That would work too depending on how the plenmum was attached
to the manifold.

Paul Lamar

I'm sorry, but I still don't get it. Tracy's dynamic chamber (the outer runners)
stops short of the oil filler tube. The only problem I see is how to get air into
the dynamic chambers. Tracy's way of feeding it from the top seems the optimum in
terms of air flow (the return wave is slung around the outer radius of the dynamic
chambers and new air is feed from the top.

But I don't want to cut a hole in the top of my RV-3 cowling!

Seems the only other solution is Paul's idea of coiling the runners on the intake
side of the engine. Is there any liability (flow wise) of having the air go
through 360 degree bends (spirals), providing the injectors are all on the engine
side of the spirals?

Finn

Well you can use the dynamic chamber if you wish. 
I suspect Tracy's engine is tuned a bit too high as he is seeing
as much as 6600 RPM.

You RV4 guys got a lot of room over the engine. In my case it would cause
an ugly scoop on top of the cowl. That is if I were 
not using a turbo like I am:-)

Not my idea. The LS1 Corvette V8 engine was the first to use it 
I think. It is now universal in almost all V engines built around
the world. The curved runners do not appear to hurt or nobody
would be using them. If you inject fuel it has to eventually go
down the runner sooner or later. It does not just disappear.
If it evaporates all well and good. That is ideal mixing
of air and fuel. That is the whole point of injecting
it at the start of the runners.

The auto guys inject it close to the engine for better throttle
response reasons.

The other thing about tuned runners is the engine tends to get
the best BSFC at the tuned length. So for best BSFC it should
be tuned for cruise RPM. This should really show up when
we get a variable pitch prop and we can run the engine at
wide open throttle at say, 4500 RPM. Its like having overdrive
in a car.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org