Seems the oil filler tube is right in the way of an optimum
length tuned intake manifold. The plenum wants to go right
where the tube is. You could hack saw it off and use a die grinder
to grind out a part of the tube so you could use a sharp
chisel to get the rest out. Tracy said he griped it with
vice grips and worked it back and fourth until it came
out. Make sure you do all this with the center housing
disassembled so you don't get any metal particles
in the oil system.
Paul Lamar
mike h wrote:
What about using the turbo motor (87-91) oil filler? It bends and runs
forward (to the front housing) and then up, to avoid the top-mounted
intercooler on the FC3S cars.
You could always cut and weld an extension if it doesn't go far enough in
any particular direction; and of course you'd have to remove and reinstall
so it pointed towards the flywheel.
Mike Harrington
I looked at that Mike. I don't think it is low enough for a Kis
Cruiser cowl. Its tight.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org