I looked at that Mike. I don't think it is low enough for a Kis Cruiser
cowl. Its tight.

Paul Lamar

How about welding on a piece of rectangular tubing? Rate of flow isn't
important (if you have to get back in the air *that* bad, you don't need to
be flying) so a smaller tube would work OK. See attached GIF. Pardon the pic
- the export filters for Designer are pretty crappy.

Basically, weld a rect tube onto a short stub of the oil tube, and go where
you need to with it. Should only need be 1.5" high total, maybe less if
you're a good welder (I'm not).

Mike Harrington

Hey that looks like that will work. Good idea. Thanks Mike.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org