Subject: How not to design a motor mount.
From: ACRE NL
Date: 7/5/2001, 1:19 AM

http://www.sdsefi.com/rv4.htm

"The mount is now substantially done except for powder coating. It took 83 hours to ["]engineer["] and build. Weight for the 3 components is about 21 lbs vs. 14
for the Lycoming mount. 31 feet of 3/4 tubing was used. 6 engine pickup points are used which are fully triangulated. This mount is exceptionally strong
and offers better nose gear support than the factory mount."

This guy would be dynamite if he would go to engineering school
for a few years. This motor mount has no less than six (count them)
six rubber bushings :-) The aft four are near useless. 21 pounds
indeed.

Off course it will work.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

SDS-RV6-motormount.jpg

SDS-motormount2.jpg