Chris - "From a quick shot off a running horse", it loooks like, with the
narrow "V" in the tail, That you might be short on horizontal tail
volume coefficient. Most current thinking on "V" tails set the effective
area as being projected area, and thus would have the same frontal
and skin area as an equivalent conventional tail, for no gain.
Just a nit from the outlying fringes - looks like a neat project, and
the workmanship from the pictures appears to be outstanding.
Vance
You might have a bit less interference drag even though
the wetted area might be the same. There are only four
corners and not six.
Paul Lamar
Here's the engineer's official comments on the V-tail.
--
Chris
microcosman.com
I don't have the exact figures here, but if I remember correctly, the tail
volume is above 0.6, compared to a typical range of 0.3->0.45. (This is
figured on the basis of projected area...) Remember that tail volume is a
combination of area and moment compared to wing mean aerodynamic chord,
and we have a long, narrow wing. In addition, the tail has a fairly high
aspect ratio, better matching the slope of the tail lift-vs-AOA with the
wing. This further reduces pitch trim drag.
It's true that the savings in wetted area is mostly a wash; however you are
also saving profile area (and its associated drag) and the drag of a third
moveable surface with its hinge and slot, as well as the intersection drag.
Under otherwise identical conditions, the V-tail Bonanza was always about
3% faster than the straight-tail version. I believe this would have
been even greater if the Bonanza tail had a higher aspect ratio.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org