Subject: NACA Ducts (one last time)
From: ACRE NL
Date: 7/6/2001, 11:58 AM


 > >>  YES!! now I have two  ways to go and I like both of them.  The P-47
 >>  version is  sooooo easy.  And it does not add one bit of drag.  The
 >>  stock cowl has an intake tunnel to the carb.  I could enlarge this to
 >>  get sufficient capacity and just run it all the way back.  This works
 >>  well with the Tailwinds shape and structure. The tunnel aft of the
 >>  fire wall would be in the wind shadow of the bottom of the cowl.
 >>  The regular cooling intakes could be eliminated.       I will get the
 >>  rad asap and get it mounted,  Then I will mock up the various intake
 >>  schemes and have a look.  I should have my drive in a month.  With it
 >>  installed, the cowl can be developed.  Things are started to roll.
 >>
 >>  I have read on this list that the thinnest rad cores were the most
 >>  efficient.  I based my rad design on 1" tubes in two rows.   In one
 >>  of your recent statements, you recommended using  1.25" tubes as
 >>  these would flow better.  I can choose between a 20" square 1" two
 >>  row   or an 18" sq 1.25" two row.  They are roughly the same
 >>  capacity.  Which would you recommend?  Thanks,  Jerry
 >>
 >>    Jerry

 >I would not exactly say it does not add one bit of drag.
 >The frontal area of the aircraft is increased and there
 >is skin friction inside the tunnel. The frontal area of
 >an aircraft is defined as the max cross sectional area which
 >does not necessarily occur at the front of the aircraft.
 >It is going to make the Tailwind look a bit more like
 >a Howard DGA.

 More like Chuck Dunlop's beautiful cowl, just a little smaller.   I
 have not heard back from Griffin yet.   What is the size of Chuck's
 inlet?     --Jerry

I think he is changing it as we speak. What is the new size
going to be Chuck?

Paul Lamar

A sketch  to explore the concept: Jerry

I got it this time Jerry. Some essential suggested changes in red.
50 square inches is not enough. Particularly if you are going
to tap off induction air. More like 100 square inches is
called for. A duct 5 by 19 would be more like it.
I am sorry but you cannot get a quart in a pint pot.

On the other hand if you flew your airplane upside down
on the back of a pickup truck and you proved to me
you had at least 20 pounds per square foot or .144 PSI
or two inches of water on the face of a blocked off rad
at 100 MPH I would sign off on a smaller duct :-)

Paul Lamar

 [Image]

Kill that blocked off part. The pressure must be there
with the air flowing through the rad.

With it blocked off and the duct sealed a one inch hole will show
26 PSF.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org