Subject: Oil Filler Tube Removal & motor mount.
From: ACRE NL
Date: 7/6/2001, 4:20 AM


Lonnie wrote>
Attached is a picture of my oil filler cut and angled over to make room
for
the intake.
Lonnie Wood

Mark wrote>

That is a very clean looking engine mount installation. Are those modified
stock mount brackets? How is this braced for side loads?
Mark Wrathall

Good call Mark. I had not noticed that.
I think you need some diagonals Lonnie. Perhaps a bent tube
down and under the pan with diagonals from the center of that.
The tops are more of a problem.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Lonnie-Wood-oil-filler.JPG