Subject: Oil Filler Tube Removal (Was New Manifold)
From: ACRE NL
Date: 7/6/2001, 2:56 AM

George Lendich wrote:

Attached is a picture of my oil filler cut and angled over to make room
for
the intake.
Lonnie Wood
 
Very neat job Lonnie !!
No problem with the cut and shut !?
A bit of bent tube and you could run it anywhere.
My only concern would be the welding in situe,
in regard to heat ,which I believe would be eliminated with a wet rag
around the pipe.

George (down under)

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org