Subject: Cosman Mark II - V tail
From: ACRE NL
Date: 7/9/2001, 6:04 PM


Russell Kent wrote:

Chris,
I hope your design omits the Bonanza's nausea-inducing yaw wallow.  :-b

Russell Kent

Gee, me too.  Although I get conflicting reports on this phenomenon.  My
grandfather used to own one and vigorously disputes the claim.  I wonder if
it doesn't have to do with loading the airplane too close the the aft CG
limit, thereby making the airplane more pitch divergent, which in a V tail
might also make it do the yaw boogie.

Beech, in an effort to increase the load carrying abilities of the airplane
did enlarge the empenage surfaces (without beefing up their spars - to
disastrous end) and I also wonder if the weak spar-ed empenages were
twisting/flexing in such a way as to contribute.  I'll never know.

We've already tested a tail spar to destruction.  Each side has a fore and
aft spar with the ruddervators attatching to the aft spar.  I'll have to
shuffle through the notes here to find the final breaking point.

We're also looking at making it a flying tail (ala Mooney)  for drag
reduction and lots of trim authority.  If anybody has a reason not to do it
this way, I'd appreciate knowing.

Chris
microcosman.com


Concentrated loads in the pivot mechanism not well suited
to composite construction. Not impossible. Look at an old
Lotus Elan's door hinges. They used large nylon ball and socket
joints that distributed the stress into the composites much
better than bolted metal joints.

I might have some suggestions so send me a sketch
of the hinge you have in mind.

Paul Lamar


I still say that the Bonanza moved around in flight because of the flat surface
of  the rear fuselage.  It wasn't enough movement to be a wallow though.  Tip
tanks and the Skeg dampened it to almost nothing.
Roger Robertson

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org