Subject: PSRU plate motor mount
From: ACRE NL
Date: 7/10/2001, 8:53 PM



Ken Gillanders wrote:
Paul,
Could you or Bill give me the dimensions for the pockets that will cut a
few
pounds. I'm no engineer and do not know how to do a finite element
analysis.
I don't feel comfortable making this detemination as other peoples lives
will be depending on this mount. I do not know how much meat should be
on
the beams. I would like to get all the information and then take it down
to
Kearny's. Thanks for the DXF file. I will forward this and your drawing
to
Kearny's this afternoon. Maybe hold off on shipping Tracy's plate, it
might
be to expensive if there only a 5-6 done save you on shipping if this is
the
case.

Ken Gillanders


This plate as is... is way overkill.

The idea is to come in from both sides the same .2" amount to minimize
residual stress warping. Leave about .1 inch thick web and scale
it off this drawing. If that proves to be bothersome I will add
some pocket dimensions. I can also send the ACAD 11 DXF in a few hours.
Where you able to load Tracy's DXF?

BTW make the parts holding the rubber bushings 2.25 inches wide
instead of 2 inches wide.

Paul Lamar
Paul,


I thought it is overkill, but I wanted to make sure as this is a critical
part to the airplane.  I was not able to load Tracy's DFX file, I think I
got it the first time it came over a few months ago. I caught your earlier
posting on the tabs to make them 2.25" instead of 2". BTW  29" wide
centerpoint to the bushings would leave enough room for the turbo, right? I
got it on the pockets.

Ken

Yes on the 29 inches. In fact I could space the turbo out another
one inch if I need to make room for the RB Wagner bends intake 
manifold.

This one was done by Bill Schertz from Tracy's DXF.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Bill-Schertz-kis-mm-plate.gif