Ken Gillanders
This plate as is... is way overkill.
The idea is to come in from both sides the same .2" amount to minimize
residual stress warping. Leave about .1 inch thick web and scale
it off this drawing. If that proves to be bothersome I will add
some pocket dimensions. I can also send the ACAD 11 DXF in a few hours.
Where you able to load Tracy's DXF?
BTW make the parts holding the rubber bushings 2.25 inches wide
instead of 2 inches wide.
Paul Lamar
Paul,
I thought it is overkill, but I wanted to make sure as this is a critical
part to the airplane. I was not able to load Tracy's DFX file, I think I
got it the first time it came over a few months ago. I caught your earlier
posting on the tabs to make them 2.25" instead of 2". BTW 29" wide
centerpoint to the bushings would leave enough room for the turbo, right? I
got it on the pockets.
Ken
I also have this. Is this the latest and correct Tracy?
BTW Tracy I sure wish you would send us another bmp of that drawing
with relatively larger dimension text on it. Could you do that for us?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org