Don't forget Mark. This plate does double duty. As such it is a weight
saver even if it is not pocketed out on an NC mill. Those center
housing mounts would be heavy. Also it would be tough to get the
mounts on the center housing and still get the turbo on there with
out building something heavy down low well under the turbo.
this scheme also gives room for an under the cowl muffler.
BTW Ken, if you do pocket it out I am in line for one just to save
the two pounds or so and look cool :-) Perhaps you can slap mine
in the NC mill and pocket it out while you are at it :-)
Paul Lamar
Ken Gillanders wrote:
Paul,
Could you or Bill give me the dimensions for the pockets that will cut a few
pounds. I'm no engineer and do not know how to do a finite element analysis.
I don't feel comfortable making this detemination as other peoples lives
will be depending on this mount. I do not know how much meat should be on
the beams. I would like to get all the information and then take it down to
Kearny's. Thanks for the DXF file. I will forward this and your drawing to
Kearny's this afternoon. Maybe hold off on shipping Tracy's plate, it might
be to expensive if there only a 5-6 done save you on shipping if this is the
case.
Ken Gillanders
This plate as is... is way overkill.
The idea is to come in from both sides the same .2" amount to minimize
residual stress warping. Leave about .1 inch thick web and scale
it off this drawing. If that proves to be bothersome I will add
some pocket dimensions. I can also send the ACAD 11 DXF in a few hours.
Where you able to load Tracy's DXF?
BTW make the parts holding the rubber bushings 2.25 inches wide
instead of 2 inches wide.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org