Subject: PSRU plate motor mount.
From: ACRE NL
Date: 7/10/2001, 7:50 AM

Wrathall Mark wrote:

Paul wrote>
I also forgot to mention the effect of thrust on the rear
mount load. Looking at the engine from the left side the thrust
line is above the rubber bushings by several inches.
Assume 500 pounds of thrust so there will be a 1500 inch
pound counter clockwise moment in the vertical plain.
Since the rear mount is 18 inches aft the moment load
will be 83 pounds UP on the rear mount. 83 pounds up
minus 55 pounds down is a net load of 28 pounds up
on the rear mount. The loads are low back there.

Mark wrote> Paul, I think this is bogus logic (although it doesn't change
that it is a good design). What you are saying is that there is little load
on the rear mount during high power cruise.

I thought your design point for the mount system is a really badly botched 6
G landing isn't it? Under those conditions you will have some compressive
load on the aft mount. I haven't got your figures to work that through, but
thrust during that landing will not help much.

Mark Wrathall

Absolutely true Mark. In that case the load on the rear mount with 
a wood prop will be 330 pounds and 600 pounds on each front mount.
Less on the rear and more on the front with a constant speed prop.

In Mike Wills case the the upload on the rear mount will be about 
500 pounds as the CG  of the engine/prop/psru  is ahead of the mount  
by about 3 inches. The down load on Mike's front mounts 
will be higher by half that or  about 850 pounds each side. 
More on the rear and more on the front with a constant speed prop.

There will also be some tension load on Mike's
rear mount. It is hard to say what the exact rear mount load would be as 
much depends on the actually stiffness of Mike's rear tubes in bending.  
Not to mention the stiffness in the rubber bushings involved.
Without a complete FEA it is hard to say exactly.

In the case of the Power Sport design it would be all tension
in the top/rear mount. The Power Sport top mount design also 
successfully reacts some of the engine torque.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org