Paul wrote>The secret to making a simple mount is use two large rubber
bushing located near the engine/psru/prop CG on either side
of the engine.
Mark wrote> Paul, looking at your PRSU/motor mount plate, this doesn't look
to me to be that close to the CoG. If tracy's PSRU can balance a whole built
up engine, it is probably too heavy :) Or are you going to mount a Hercules
prop.
I understand the way you have done your mount for your aircraft as width is
not an issue, and this gives you max radiator space, but the further you
displace the main mounts from the CoG, the more load the aux mount will see.
It would be logical to me to displace this main mount rearwards, allowing
shorter lighter mount tubes than forward. Especially if Mazda provided
mounting points on the center housing.
There is no doubt about it Mark. The plate is ahead of the CG combination
particularly with a wood prop. With a constant speed prop the
CG will be within and inch or two. Butch is working flat out on
the constant speed electric prop. The distance from the rear
housing mounting surface to the prop flange is 14 inches.
The design currently is a compromise with the mounts probably
three or four inches ahead of the wood prop combo CG.
The load on the rear mount is still low however as it is about 12 or
14 inches further back. 4" times 250 # = 1K inch pounds divided
by 18" is about 55 pound static load on the rear mount.
There is no torque load on the single rear mount.
I wanted to make a magnesium bell housing casting with the mounts moved aft
three inches in line with the mounting surface but that did not
work out as there was little interest at the time. Interest is picking
up. Perhaps sometime in the future when there is more demand
this would then be ideal. PL
Could any of the guys with a finished installation give us an idea of where
the CoG is with the full built up engine PSRU and Prop installed? I would
guess about the join between the center and rotor housings on the Prop side
of the engine, very close to the center housing mazda mounts. Those people
who have used those mounts have still built Aircraft style mounts with equal
load capacity to some top mounts. LyCon dynafocal type mounts need to look
like that because the engine is fully cantilevered off its rear housing.
If I am right about the CoG position, the lightest mount would be Pauls two
tripods picking up the center housing mounts (I know that these are not on
all 13B's) with the simple strut setting the thrust line.
Mark Wrathall
Don't forget Mark. This plate does double duty. As such it is a weight
saver even if it is not pocketed out on an NC mill. Those center
housing mounts would be heavy. Also it would be tough to get the
mounts on the center housing and still get the turbo on there with
out building something heavy down low well under the turbo.
this scheme also gives room for an under the cowl muffler.
BTW Ken, if you do pocket it out I am in line for one just to save
the two pounds or so and look cool :-) Perhaps you can slap mine
in the NC mill and pocket it out while you are at it :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org