"Brian D. Cain" wrote:
Hey guys, I wanted to toss up an idea towards you guys. Per talking with a
friend of mine, Jim Ratichek who's on this list, he's given me some ideas
for ducting airflow through the front-air damn of my Mazda Rx7. I would
throw this out on the vehicle mailing lists, but quite honestly alot of
those guys have no engineering skills nor any clue what they're talking
about sometimes.
Anyhow, I'm experimenting with a turbocharger air-to-air intercooler and am
having some problems keeping water and oil temperatures down. Per this
picture,
http://www.angelfire.com/home/rx7turbo/BdcT2/GozaCatchCan/GozaCatchCan10.JPG
, you can see where I've mounted the intercooler core in the front-bumper
area. Unfortunately, that along with the combination of not having an
underpan has risen my water temperatures from the 170F's to mid 180F's to
190F flat as well as my oil temperatures from high 160F's to almost 200 to
205F. The oil cooler is mounted two inches lower than it should be per the
factory-installed position.
Based on you guys' experiences, what happens with the efficacy of heat
exchangers doing their job when two exchangers are stacked back-to-back with
little to no airspace in between? Is this a good idea or bad idea? The idea
I had here was to mount the intercooler core where the radiator currently
rests and then sandwich the radiator behind the intercooler core towards the
front cover/pulleys. I could care less about aesthetics but rather making
the cores and airflow through this front air damn, to the radiator in
eventuate, as efficient as possible. My friend says that it will have an
effect on the efficiency of the radiator if the intercooler core is mounted
smack-dab in front of it but he's not sure why.
Ideas? Stuff it car-guy? =)
(And yes, those are Dave Atkins' 13B pulleys on a street-driven vehicle)
B
If you have a limited amount of space, and you do Brian, stacking
them is your only alternative. Pass the hot air through the one in
the back and then and only then through the one in the front.
It is not as good as an intercooler with twice the frontal area
but it will be better than only one. What kind of intake manifold
temperatures are you seeing now? Very important to know how well
things are working or not working.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org