If you have a limited amount of space, and you do Brian, stacking
them is your only alternative. Pass the hot air through the one in
the back and then and only then through the one in the front.
It is not as good as an intercooler with twice the frontal area
but it will be better than only one. What kind of intake manifold
temperatures are you seeing now? Very important to know how well
things are working or not working.
Paul Lamar
"Brian D. Cain" wrote:
That's what I was thinking Paul, but I didn't know if stacking the radiator
directly behind (engine-side) the turbocharger intercooler (mounting the
intercooler where the radiator is now per that picture) would make
either of them less efficient. I tried mounting the intercooler in the
front
bumper but it impeded the airflow to the oil cooler too much. Of course,
the factory ducting is the pits ...
I'm currently seeing intake air temperatures between 130F and 155F when
hard on the throttle with the factory top-mounted intercooler unit. I
believe
there to be a real problem with the aerodynamics of the hood and the
efficacy of the hood-scoop as a means of getting fresh-air into and through
that core. That's why I'm replacing it and am going to try a larger unit.
Plus, it heat-soaks badly sitting smack-dab on top of that engine.
I know you guys know what the heck you're talking about so that's why I
asked.
Thanks for the reply.
B
Certainly does decrease the efficiency of the water radiator by
putting an intercooler in front of it. You are right
about that top mounted intercooler and your data seems to verify
that. You should be able to get the intake temps below 130 degrees F
with one new intercooler in front of the rad. It looks like
you have a larger than stock water rad anyway.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org