Subject: Stacking heat exchangers -> Good idea or bad idea?
From: ACRE NL
Date: 7/10/2001, 10:56 PM

Jim R wrote:

If you have a limited amount of space, and you do Brian, stacking
them is your only alternative. Pass the hot air through the one in
the back and then and only then through the one in the front.
It is not as good as an intercooler with twice the frontal area
but it will be better than only one.

[snip]

Paul, that's a radiator and an intercooler, not two intercoolers.  Brian and
I had discussed this earlier, and I thought that putting the two cores back
to back was not as good as having a few inches of separation from a flow-
standpoint.  I mentioned that some air temp probes might help evaluate the
issue.

Correct me if I'm wrong, but I believe that sealing up the flow of air
through the nose/IC/radiator combination is more critical than whether the
radiator and IC were mounted back-to-back, or separated by a few inches.
Currently, his setup has a lot of gaps on the sides of the radiator, IC,
etc.

Thanks for the help.

Jim

Yes I assumed that would be done. Most car makers are real cavalier
about ducting. If they ever figure it out and start to 
use a Kuchemann and Weber proper duct watch out... :-)

It amazes me the NASCAR guys have not appeared to catch on yet.
I had a talk with Ron Davis a few weeks ago about this and he
has a lot of NASCAR contacts so perhaps we will be seeing some
improvement in the near future.

Brian seems to be with it as far as data taking is concerned.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

me109duct3.gif