Subject: Stacking heat exchangers -> Good idea or bad idea?
From: ACRE NL
Date: 7/11/2001, 10:15 AM


Brian D. Cain wrote:

Hey guys, I wanted to toss up an idea towards you guys.  Per talking with a
friend of mine, Jim Ratichek who's on this list, he's given me some ideas
for ducting airflow through the front-air damn of my Mazda Rx7.  I would
throw this out on the vehicle mailing lists, but quite honestly alot of
those guys have no engineering skills nor any clue what they're talking
about sometimes.

Anyhow, I'm experimenting with a turbocharger air-to-air intercooler and am
having some problems keeping water and oil temperatures down.  Per this
picture,
http://www.angelfire.com/home/rx7turbo/BdcT2/GozaCatchCan/GozaCatchCan10.JPG
, you can see where I've mounted the intercooler core in the front-bumper
area.  Unfortunately, that along with the combination of not having an
underpan has risen my water temperatures from the 170F's to mid 180F's to
190F flat as well as my oil temperatures from high 160F's to almost 200 to
205F.  The oil cooler is mounted two inches lower than it should be per the
factory-installed position.

Based on you guys' experiences, what happens with the efficacy of heat
exchangers doing their job when two exchangers are stacked back-to-back with
little to no airspace in between?  Is this a good idea or bad idea?  The idea
I had here was to mount the intercooler core where the radiator currently
rests and then sandwich the radiator behind the intercooler core towards the
front cover/pulleys.  I could care less about aesthetics but rather making
the cores and airflow through this front air damn, to the radiator in
eventuate, as efficient as possible.   My friend says that it will have an
effect on the efficiency of the radiator if the intercooler core is mounted
smack-dab in front of it but he's not sure why.

Brian,
I am slightly confused.  You bemoan your high water and oil temps, and then you ask
about adding a second intercooler.  Cooling your intake charge is only going to
have a slight effect on your water and oil temps, and by dumping the intake
charge's heat into the radiator's and oil cooler's air, you make it even harder for
them to shed their heat.  But I'm sure you knew all of that.  :-)  Do you have an
intake charge temp problem that you forgot to mention?

If not, you'd do better to add another radiator (plumbed back to front) between the
existing intercooler and radiator.

Russell Kent

Adding just one Russell. Had me confused too.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org