Subject: 13B on a Cozy IV
From: ACRE NL
Date: 7/15/2001, 10:48 AM

John Slade wrote:

Hello Paul and fellow Rotarians,
I spent yesterday evening trial fitting my 3rd Gen. 13B to my Cozy IV
firewall.

I've posted some pictures at http://kgarden.com/cozy/chap23e.htm

I want to get on with making the upper cowling plug, but before I do I
thought it might help to get a few expert opinions based on the pictures
I've posted.

The issues that I'm considering are:

1. The stock water pump is a very tight fit. Can I remove the cap, block off
the top and put the pressure cap somewhere else? Where? I know the cap needs
to be at the top. 

Yes. Use a 30 psi pressure tank high up on the firewall and run a bleed line
from the back rotor housing up to the pressure tank as well as a large
line from the water pump. You will still need an overflow tank however.

or should I resort to the cut off water pump approach.  Is
there a source for these. I'd rather have a new water pump anyway.

No real need if you move the pressure cap.

2. The alternator I got is the wrong pulley type. I'm wondering if its from
a 2nd Gen. engine. Both the tension bracket and the black terminal protrude
too far up. I guess I could fabricate a replacement tension bracket. I'm
thinking I can cut the top off and weld a lug for the tension screw below
the cutout rather than above it. Then rotate the tension screw 180 degrees.
The "black terminal" looks like it can be rotated, but it has a plastic lug
which forces it into the upright position. I'm thinking of breaking off the
lug. Again - I'd rather get a new alternator anyway.

That black terminal can be remade to come out the side. 
I am doing that as well.

3. The turbo fits pretty well. I think the air outlet hose and cooling pipes
can be adjusted to fit inside the cowling with no problem.

I'm tempted to just make the cowling to the optimum shape, then change
anything that doesn't fit.

Is there anything I'm missing which would affect the shape of the upper
cowling???

I'd appreciate any input I can get.

Regards,

John Slade, Cozy MKIV #757, progress: http://kgarden.com/cozy
West Palm Beach, FL

Looking good John. Perhaps some small tubes connecting all four
rubber bushing mounts  would relieve a  bit of local bending 
stresses. Not absolutely essential with the acute angles
the motor mount tubes make with the bushing mounts.
Just check them for cracks from time to time.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

P38-engine-in-cowl.jpg