Rick Girard wrote:
Paul, thanks for the answer. I saw Ken's Coot at Arlington, it is a
marvelous piece of work. After sending out my plea, I went to see the
folks at Hayes Rotary with damper, counter balance and fly wheel in
hand. They had foreseen the problem and picked a counter balance from
stock and sent it with the rotating assy. A big thanks to the Dennis,
Don and the crew at Hayes. They took one look at the flywheel and got
me another from stock. If I weld an insert in one of the stock holes, I
can align the damper such that no probability of cracking will exist.
As for the Ross PSRU, well, the housing is nice. By the time I get
through with it using suggestions from Neil (from Alaska, whose last
name I do not know, but, who was kind enough to send me dozens of
pictures of the mods he and a buddy did to two Ross gearboxes) and
others, I'll grind off the Ross logo and replace it with my own. Once
again thanks to all.
Attached is a picture of a tool some of you might find useful. They are
called transfer punches, made by the Heimann Mfg. Co. of Urbana, OH.
Ingenious little devices, they come in a wide variety of inch and metric
sizes and make the job of transferring hole patterns a snap. Simply
screw the transfer punches into the holes so that the points just
protrude (the case which holds the punches is also the installation
tool) lay the plate on the object with the hole pattern and tap with a
hammer. Presto, the entire hole pattern is transferred at once. Best
part is each size sells for about ten bucks at Enco, McM Carr, MSC,
etc. You guys making one of Paul's engine mounts might find the job
doesn't require a CNC, with attendant programming, after all. :~)
Rick
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org