Subject: PSRU plate motor mount
From: ACRE NL
Date: 7/15/2001, 8:23 AM


Ken Gillanders wrote:

Paul, Mark and group,

The quote I got for the CNC motor mount plate including material is
$400.00-$500.00 OUCH!!! I am going to check with another source tomorrow
that was given to me by Kearny Metal. Doug at Kearney's told me that
Ron Gee
at Gee Machining in Fresno may be able to do it at a lower cost, an
recommended his work, he is a one man show with lower overhead. I'm going
over there tomorrow. As we all know the first one is the expensive one for
all the programming. He said the first one would be around $1,000.00.
Now if
we only had 20 of them made....Hmmmmmm.

Ken Gillanders

The material cost me $100. If we make ten or so having them
hydro cut would save a bunch of material and they can cut the
lightening holes while they are at it. It is a lower cost process
rather than an NC mill. Casting are $8 to $10 a pound so something like
this cast would be about $150 less machining. The pattern would
not be that hard to make.

Paul Lamar

marc wiese wrote:

I will settle for the plate and just Tracy's  PRSU holes drilled in and not
even that if not practical (but no engine mount holes). I can do the
rest-it will probably be custom anyway, different from the rest. I plan to
move the starter, etc, etc. Ken's bare plate price was great.



The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org