Subject: PSRU plate motor mount
From: ACRE NL
Date: 7/15/2001, 8:32 AM


Ken Gillanders

The material cost me $100. If we make ten or so having them
hydro cut would save a bunch of material and they can cut the
lightening holes while they are at it. It is a lower cost process
rather than an NC mill. Casting are $8 to $10 a pound so something like
this cast would be about $150 less machining. The pattern would
not be that hard to make.

Paul Lamar

Paul,
I was going to suggest casting, that way you can cast-in your weight
saving holes rather than cut them out, saves a lot of work. A flat job,
could cast in the mounting brackets as well rather than cutting the slots,
easy to vary if need be.
George (down under)

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org