Subject: PSRU plate motor mount
From: ACRE NL
Date: 7/15/2001, 2:36 PM

Neal Scherm wrote:

Hey guys,
What do you think of this engine/redrive mount plate? It uses Tracy's
redrive and a rear mount attatched to the timing cover like Atkins aviation.
It gives the engine a flat cradle to attatch firewall tubes to and a solid
mounting surface for the rubber isolators.
My friend is ready to machine it from a 1/2" plate of 6061 T6. He has it
programed on MasterCam for a CNC machine and we are going to cut it this
coming week.
Any comments?
Neal

Looks like it will work fine.
It will isolate the torsional vibrations from the rotary better
if you rotate the rubber bushings 90 degrees.

Is this for a narrow cowl like an RV4? If not 
 moving the mounts out will give more room around
the engine for exhaust systems and or turbo chargers.

You won't need much of a rear mount at all as this plate will
take 90% of the load. A couple of rod ends and a bracket on
the firewall would be all you need.

The lightest and simplest engine mount is just two rubber
bushings on either side of the engine close to the CG of
the engine/psru/prop combination.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org