Neal Scherm wrote:
Hey guys,
What do you think of this engine/redrive mount plate? It uses Tracy's
redrive and a rear mount attatched to the timing cover like Atkins aviation.
It gives the engine a flat cradle to attatch firewall tubes to and a solid
mounting surface for the rubber isolators.
snip
Any comments?
Neal
The whole idea of the four rubber bushings got started with
horizontal opposed aircraft engine bed mounts. In that case the
rubber bushing surrounded the CG of the engine in a more or
less central location. They made a lot of sense in those
circumstances. Aircraft engines, for the most part, do not
have heavy 14 inch long PSRU's extending out in front
of the engines.
In our case it is very hard to get the front mounts very far
ahead of the engine/psru/prop combination CG. Even when they are mounted
on Tracy's psru adapter plate. This means the aft two rubber bushings
will have little or no load. The CG less prop is roughly located
about 3 inches aft of this plate. The left side clockwise moment,
assuming a 250 pound engine/psru (no prop), is therefore 750 inch pounds.
The CG of the prop is located about 13 inches forward of this point.
If the prop weighs 15 pounds that will be a left side counter clockwise
moment of 195 inch pounds. The net moment then becomes 555 inch pounds.
Dividing that by the new combination weight psru/engine/prop of
265 pounds gives a new CG position only 2 inches aft of the plate.
The method of calculation would be the same as would the results,
more or less, even if the CG was a bit further aft of the plate
then stated here.
Obviously what is called for is the two larger rubber bushing,
one on either side of the engine, mounted off the adapter plate.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org