Brian,
I am slightly confused. You bemoan your high water and oil temps, and
then you ask
about adding a second intercooler. Cooling your intake charge is only
going to
have a slight effect on your water and oil temps, and by dumping the
intake
charge's heat into the radiator's and oil cooler's air, you make it even
harder for
them to shed their heat. But I'm sure you knew all of that. :-) Do
you have an
intake charge temp problem that you forgot to mention?
Well, I am bemoaning the high water and oil temperatures as a result of the
addition of that
turbocharger intercooler, unplumbed, as a test in the front bumper area.
Normally, not
withstanding the high 90F's/low 100F's ambient temperatures out here in the
good 'ole Texas
summer heat, water temperatures rest between 165F and 180F and oil
temperature sit
in the 170F's or so. Given the heat lately, they're both up a hair-bit,
moreso the oil temperatures.
In any case, both of those temperatures rose when I placed the turbocharger
intercooler
core in the position it was in per the already-pasted picture/URL.
One reason I think they did was because I could not put the factory underpan
back on, and I
believe this led alot of the incoming mass air to shoot out and below the
vehicle rather than
being forced through the heat exhangers. So, the idea I had to try and
resolve this by hopefully
getting the 'best of both worlds' was to have the underpan in-place (perhaps
a sheet-metal one
with few hard-bends and _no_ escape routes for the air, proper ducting, and
the stacking
of the intercooler in-front (nose-side) of the radiator (engine-side), hence
the original query
about the efficacy of the radiator if another exchanger is sitting right in
front of it without any
airspace in-between. My buddy Jim says the problem is more on the ducting
of the air through
to the exchangers rather than the stacking of the two exchangers themselves.
For the
displacement of the engine, as you already well know, the radiator is very
oversided. The oil
cooler, in my opinion, is already very efficient as well, so I don't think
there'll be any problems
once it's all setup. I was just originally wondering if stacking two heat
exchangers, back to back
like a sandwich, would be a detrimental problem.
If not, you'd do better to add another radiator (plumbed back to front)
between the
existing intercooler and radiator.
Russell Kent
Adding just one Russell. Had me confused too.
Paul Lamar
I probably didn't do a well-enough job in explaining myself. =)
B
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org