Mike, that cowl is a thing of beauty. You must be reading my mind-
that's how I imagine mine looking, even down to the NACA duct for engine
air. My exhaust will go down under the fuselage, though. Did you use a
bigger spinner and extend it forward campared to the stock spinner
location? If it works half as good as it looks, then you've got a winner.
Brian Trubee
Redmond, Wa
Mike Wills wrote:
Brian,
Yes the engine was relocated forward slightly (to allow more rad room).
Probably wasnt necessary but I think the RV4 can stand the cg shift better
than many designs.
The spinner is a 16" diameter piece form Mustang Aeronautics (versus 13"
for the stock Vans spinner). Makes it much easier to clear the starter and
intake manifold. And should look pretty good when I get it polished.
Mike Wills--
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org