Paul,
I have been looking at those NACA ducts and it seems to me to be somewhat of
a bell shape.
Your comments ?
Would this shape be good for exit ducts also !?
George (down under)
I don't think so. The whole idea of a NACA duct was to deal with a
boundry layer and you don't have a boundry layer when the
air exits the rad.
>Paul Lamar
The curve in the NACA duct helps induce a pair of inward rotating
fixed vortices. These pull themselves down into the inlet and cause
the inlet to work. I can't see how this would happen in reverse.
Bill
Charlie Kuss wrote:
Bill & Paul,
RV builders are experimenting with installing fuselage ventilation exhaust ducts at the
rear of the tail cone. It has been found that the installation of these ducts, improves
cockpit ventilation and prevents the lifting of the canopy from the fuselage. (The loss of
air seal between the canopy and fuselage causes considerable draft for the passenger on
tandem models. It also increases the interior noise level.)
The most common exhaust duct shape used so far is a reversed NACA duct. Are there more
appropriate shapes for this job?
Charlie Kuss
RV-8A fuselage
Boca Raton, Fl.
There is always low pressure over the canopy with a low or mid wing
airplane. The problem with the canopy should not be solved by lowering
the pressure in the cockpit. That could draw in exhaust fumes. Better
to have high pressure in the cockpit. My suggestion is beef up the
canopy frame with steel tubing or carbon fiber both of which is much
stiffer than aluminum. Add another latch if necessary.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org