Ken Powell wrote:
Ed's post reminds me of the pressure distribution diagrams that I
have seen for both the P-51 and the RV-6 - this area of the cowl is
usually a low pressure area. I have even considered an exit duct
in this location. Mike, take a look at the RV-6 pressure
distribution that we discussed last year and you will see what I
mean (actually, I hope that I am wrong!). You may need to make
this NACA duct into a scoop. Sorry that this did not occur to me
the first time I saw the cowl pictures.
Ken Powell
kenpowell@aristotle.net
It is neutral to moderately low up there Ken on the P51.
I think the NACA duct is going to work fine on Mikes cowl.
Paul Lamar
Alfonso Lebron-Berges wrote:
I am not an aerodynamycist but can't understand how a NACA duct will
operate in an area where pressures are neutral, or at least operate
efficiently. What am I missing?
Alfonso Lebron-Berges
It like Bill says:
The curve in the NACA duct helps induce a pair of inward rotating
fixed vortices. These pull themselves down into the inlet and cause
the inlet to work.
Bill
This implies that the velocity of the air leaving the scoop
internally is about the same as the air velocity entering the scoop.
Air is viscous so those vortices drag more air down into the scoop.
There is always a velocity continuum in any moving fluid. In other words
there is always a velocity gradient between two masses of air moving
at different speeds. The high speed air drags along a certain percentage
of the low speed air in its immediate vicinity. Over a distance
the high speed air is forced away from a surface by friction and
a thicker and thicker turbulent boundary layer is built up adjacent to
the stationary surface. This is why NACA ducts don't work well
in high boundary layer thickness areas.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org