When I initially overhauled my 20B, I measured my end play to be 0.0035"
which is considered the utmost upper limit. The target endplay is 0.0016" -
0.0028"
I did not initially change the spacer out to take up this endplay but am
ready to do so now prior to permanently sealing up the front cover.
If I want to get my endplay into the center of the target range (0.0022"), I
need to obtain a spacer which is 0.0013" thinner. The spacer that I have now
is exactly 8mm. All spacers on the Mazdatrix website
(http://www.mazdatrix.com/b5.htm) are listed in millimeters also. So, if I
convert my numbers to millimeters, I need a spacer that is 0.03302 mm thinner
than the 8.0 mm spacer that I now have. That means I need a spacer close to
7.96698 millimeters, RIGHT??? So now I go back to the Mazdatrix website to
look at the spacer chart. Looking at the 93-95 column, I can't tell which
spacer I need. I don't understand the way they have these spacers listed.
Can anyone help my out here and tell me if it sounds like I've calculated
this out right??? I'd appreciate any help you can provide here!!
Thanks,
Don
I am looking in the catalog and it is very confusing. I can't figure it
out either. I would call them or send Dave Lemon at Mazdatrix email.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org