Subject: My new oil pan
From: ACRE NL
Date: 7/22/2001, 3:06 PM


Here it is with the rad mounted under the engine.
Now you know why I went to all that trouble on the motor/psru
plate with the built in motor mounts and the new custom oil
pan. Mainly to give room under the engine and within
the cowl for one rad big enough to cool 250 HP.
The rad core is 15 by 19 by 2 inches thick.

The filler neck at the front of the Howe Chevy rad will be cut off.
In fact I am cutting off the entire front tank and will
weld on a new contoured one that takes less room. The rad
will be converted to a double pass with inlets and outlets
on the back end. Might be easier to specify this core and have
Howe or Griffin supply a double pass.

Next comes the foam male mold for the rad scoop. I will test
the finished scoop  on the Dodge Caravan mounted sideways in
the open sliding door. I have a digital wind speed meter that I
can survey the flow all over the back side of the rad from inside the
Caravan. The rear windows of the Caravan open like cowl flaps :-)
I could also use my free furnace squirrel cage blowers.

Paul Lamar

Bulent Aliev wrote:

It looks very good Paul. How will you handle trapped air in the high end of
the radiator?

I am thinking of cutting some large holes in the PSRU/motor plate.
I will check the pressure in there first with a water manometer to see
if they are really needed.
I am also going to seal the cowl really well. Especially around the PSRU
opening. The right side stock air scoop will feed air to the 
intercooler and the left side will be closed off completely.
My turbo charger air will come either from a NACA duct on top
of the cowl as the turbo sucks air or a P38/Me109 type car air 
snorkel scoop. Depends on which is faster.

The oil rad will be along side the water rad. I am thinking of using
two. One on each side of the water rad. I have plenty of room for
that.

Here is a picture with the stock Kis cowl on to prove that the rad fits
inside the cowl. I still need to fix the front rad tank to make the
cowl fit a bit better. It's been a tight squeeze. My goal
all along has been to fit everything inside the stock cowl.
Actually I have too much space under the rad in the stock
cowl so I will be able to trim some of it off and blend
it better with the fuselage. Looks kind of dumpy as it is.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

cowling-on.jpg