Charlie Kuss wrote:
Bill & Paul,
RV builders are experimenting with installing fuselage ventilation
exhaust ducts at the
rear of the tail cone. It has been found that the installation of these
ducts, improves
cockpit ventilation and prevents the lifting of the canopy from the
fuselage. (The loss of
air seal between the canopy and fuselage causes considerable draft for the
passenger on
tandem models. It also increases the interior noise level.)
The most common exhaust duct shape used so far is a reversed NACA duct.
Are there more
appropriate shapes for this job?
Charlie Kuss
RV-8A fuselage
Boca Raton, Fl.
Mark Wrathall wrote>
As has often been stated, the NACA duct mounted foward is shaped to create
vortices (notice the shape similar to the concords wing, which uses vortex
flow at high AoA) which spiral into the duct, ingesting air.
The RV guys may use it reversed, find it works, and then the idea becomes an
urban legend.
If you reverse the NACA duct and blow air out of it, it is just a lot of
work to make a fancy shape which makes no difference. It should work fine.
Not better than a nomal parallel sided outlet. Has anyone every seen a
reversed NACA duct on any professionally engineered aircraft!
Not me :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org