"Bass, Jerry" wrote:
For my two cents. I read on this newsletter that we need about 80 sq.
inches for 200 hp. Does that ratio hold for 300, or 120 sq. inches inlet.
["300, or 120 sq. inches inlet" rad core area?] PL
I raised my inlet from 50 to 80 with great cooling results, yet am still
not
pleased at 95F oat. Mine also look very draggy'. Something about air
speed
through the radiators to make them cool, not just blow through.
Jerry Bass
Jerry did you seal the area around your PSRU where it sticks through
the cowl? Very important. Also Tracy mentioned at OSH he put a radius
on his fire wall outlet area and it improved the cooling. Here is a
good example on a Lancair Tigress with a water cooled Orenda V8.
Paul Lamar
"Bass, Jerry" wrote:
Same as Tracy's Radiators. Just enlarged the air to them. Have not put
gasket around Spinner to cowl. Have 1/4 inch gap there. My nose wheel
support goes down through the exhaust/ air outlet area. and there are a
bunch of pipes, tubes to get around if I make the rounded outlet as Tracy
suggest.
Thanks for the help, I now have a computer at home hooked to the net, and
hope to contact you from there. It would keep the CO. computer less busy.
Jerry Bass
Believe me Jerry it is worth the trouble.
Here is a picture of what Chuck Dunlap did down there.
Chuck also said it made a larger improvement.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org