Hello group,
I was happy to find the my 20B engine has a dual thermostat and thought I
would share a pic with the group. This seems like a good idea just in case
on sticks. The other will still work thus allowing 1/2 the normal flow.
Failure of one might be picked up by an increase in coolant pressure above
the baseline since the flow path would be reduced by 1/2. Any ideas on
this??
Don Mitchell
No pic Don but please send them as jpg if you can.
That is not the reason they have two. If any one of the two
fail you have serious problems. It is much lower aerodynamic drag
to control the temperature of the engine with cowl flaps anyway
instead of thermostats. My suggestion is take them out
and block the bypass passages. Again there is a lot of info
on the ACRE NL Cd on this subject.
Paul Lamar
Paul, this is the same kind of thermostat like the one from my 13-B Cosmo. You
did the surgery in the water pump. I didn't like it. It was huge and complicated.
Bulent
You mean the hole was huge. What is wrong with a bigger hole?
A bigger hole cuts down the resistance to water flow which is good.
Here is a picture of your pump before I sent it to you and after
I cut it down. What is complicated about it?
You mean it is hard to do. You don't need a mill to do this.
It can be done with a die grinder and a hack saw.
You can't please all the people all of the time :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org