First, there is a large sensor above each trailing plug. I've attached
a pic
so you can see what I'm talking about. I did run across a diagram on page
122 of the 86-91 Haynes Manual that indicates that there might be a knock
sensor in this location. Can anyone tell me definitively if these are
knock
sensors? I'm wondering because this seems like the ideal place to install
CHT probes since the holes are close to the plugs and are drilled down
close
to the combustion chambers surface.
Second, there is a small sensor that appears to be installed in a oil
passage on the plugs side of the engine. Its toward the back and can
be seen
in the same pic with the sensor described in the paragraph above. I
think it
is an oil temp sensor but still not sure. It appears that this is the
usual
location of a oil pressure sensor on a 13B but I'm pretty sure that this in
not a pressure sensor. Again, any ideas would be helpful. I have not yet
marc wiese wrote:
The big sensors are knock sensors as Paul said. They are the same as on the
FD 13Brew except there are 3 on the 20B vs 1 on the 13Brew and FC turbo.
The other small sensor is the water temp sensor.
Here is the 20B dyno (car with seq turbos) again in mime encoding. Seems it
depends on what email you use to get these. Do you get uuencode as well, Paul?
Marc
I read 99.9% of the jpg's people sendme.
This one obviously worked.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org