Just got my bends from RB Wagner.
Real nice if a bit thick walled and heavy.
Room for porting or Extrude Hone :-)
Easy to weld.
Real good and fast service too.
From bottom to top. One inch inside radius, two inch
inside radius and two inch inside radius 45 degree radius.
Paul Lamar
Ed Anderson wrote:
Hi Paul,
I trust that Oshkosh was a fun experience. Wish I could have been
there, perhaps next year.
I just received my 4 port flange from Jon so started getting serious
about the project and was taking measurements. Also looked over your
drawings for your manifold and I believe I may have found something you may
want to check again. I noticed that you show a distance from the forward
edge of the intake ports on the flange to the inner side of the pipe as
3.660 inches for the big tube and 3.580 inches for the smaller primary
tubes.
When I measure from the forward edge of the primary port I get a minimum
of 3 7/8 (3.875) inches to clear the rotor housing bulge and that is with
zero gap between pipe and rotor housing. I measured this by placing a
Carpenters square so that it touched the outer most dimension of the rotor
housing and extended to the plane of the flange. I then measured from the
edge of the primary port to the square.
To clear the housing with a 1/2" clearance margin between tube and rotor
housing my CL distance for the primaries tubes is 6.065 in and 6. 375" for
the secondaries. Of course if you chose a smaller margin then this distance
will, of course, decrease.
In any case, 3.660 or 3.580 from edge of port to inside surface of pipe will
simply not clear the widest diameter of my rotor housing. . If you don't
plan on taking the pipes that far or perhaps will use a Log then perhaps it
does not matter.
I could certainly be wrong or not reading you drawing correctly, but
thought I would run it by you before you started welding - just in case
{:>).
Best Regards
Ed Anderson
Thanks Ed for the heads up. I ground off part of the top of the rotor
housing. I will check my dimensions again.
There are two things I can't stand about Oshkosh. The incessant blaring
speakers with bull shit and the same noisy air show over and over again
during the week days. Somebody ought to sue them for hearing loss. That
gives me the option of leaving before the noisy air show starts on the weekend.
What Oshkosh should be about during the week is see and be seen, show and tell
and the exchange of information.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org