Russell Kent wrote:
The component in the aircraft with the highest failure rate is the pilot. While it is good practice to have "MASTER=OFF" in your emergency procedure checklist, if one is really serious about ensuring the fuel pump is off you need another mechanism.
Several people have mentioned that automobiles have crash shutdown switches. Those are a possibility, but consider that your average airplane has the potentail to encounter turbulence which could trip the sensor. No fuel pump means no power; not a scenario *I* would want to encounter in turbulence.
I keep hearing people say to use the oil pressure switch in series with the fuel pump. At least turbulence isn't a factor, but remember that the rotary will run without oil (for a while at least), but probably won't start or idle. So if you have an oil system failure, do you really want the fuel pump to shutdown, killing the engine? Sure you can then engage an override, but restarting might be a challenge.
We need to tie the fuel pump power to something that when it fails we *really* don't want fuel. I'm thinking that a circuit connected to the crank angle sensor (CAS) is the way to go. If the CAS quits, the ignition module is out-of-business, so you're not going to get power anyway, so the collateral failure mode isn't made worse. If the plane hits the ground and the engine quits, then the CAS stops, and so does the fuel. Plus you don't need an override switch to start: as soon as you crank (assuming you can crank above some minimum RPM) then the fuel pump will energize.
We need a solid state relay slaved from the CAS that remains ON so long as some minimum RPM (100 or so) is maintained. Wire the relay in the fuel pump(s) power line.
Russell Kent
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org