Subject: emergency fuel pump shut-off
From: ACRE NL
Date: 7/31/2001, 8:56 AM


Russell Kent wrote:
The component in the aircraft with the highest failure rate is the pilot. > While it is good practice to have "MASTER=OFF" in your emergency procedure >checklist, if one is really serious about ensuring the fuel pump is off you need >another mechanism.
Several people have mentioned that automobiles have crash shutdown >switches.  Those are a possibility, but consider that your average airplane has the >potentail to encounter turbulence which could trip the sensor.  No fuel pump means >no power; not a scenario *I* would want to encounter in turbulence.
I keep hearing people say to use the oil pressure switch in series with >the fuel pump.  At least turbulence isn't a factor, but remember that the rotary >will run without oil (for a while at least), but probably won't start or idle. So >if you have an oil system failure, do you really want the fuel pump to shutdown, >killing the engine?  Sure you can then engage an override, but restarting might >be a challenge.
We need to tie the fuel pump power to something that when it fails we >*really* don't want fuel.  I'm thinking that a circuit connected to the crank angle >sensor (CAS) is the way to go.  If the CAS quits, the ignition module is >out-of-business, so you're not going to get power anyway, so the collateral failure mode >isn't made worse.  If the plane hits the ground and the engine quits, then the >CAS stops, and so does the fuel.  Plus you don't need an override switch to start: >as soon as you crank (assuming you can crank above some minimum RPM) then the >fuel pump will energize.
We need a solid state relay slaved from the CAS that remains ON so long >as some minimum RPM (100 or so) is maintained.  Wire the relay in the fuel pump(s) >power line.
Russell Kent


Mark Steitle wrote:

If you're using Tracy's psru, you have easy access to the flywheel.  It wouldn't be too difficult to fabricate a bracket and mount a CAS to trigger off the flywheel teeth.  As for the control circuit... I'll have to refer that to someone with more electrical savy than myself.  -- Mark



The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org