I run a 5/8" restrictor in the water outlet. I mix 10% antifreeze
and a bottle of Water Wetter. The problem was cracking the rotor housings
through a spark plug hole. The fix was to put small cuts int the water
jacket around the plugs in order to increase surface area. It is possible
to have a hot spot boiling away in one location and have normal water
temps. I have seen the problem in peripheral port housings but never on
side port housings. Anything that Carol Smith says is a good idea, is
probably a good idea. His books "Tune To Win" and "Prepare To Win" have
great content on cooling systems and aircraft fasteners. Also welding and
aluminum and steel alloys.
Just lost one two weeks ago at the Nelson Ledges National race. We had
2nd place in the bag when a very tired apex seal lost a flake and the next
seal ran over it and broke into two pieces. This allowed the fire from the
first chamber to enter the second chamber 100 degrees too soon. The
preignition cleaned the teeth
off of the rotor gear. The rotor
stayed in index, and the driver drove it back to the pits with the
20 horse power he had left, to report a failed engine. The cast iron is
OK. The crank is OK. Today is trash day, so the rotor housing and rotor
are gone. I put it back together last night. Took less than three hours. I
love these things. Lynn E. Hanover
Lynn, were those stock cast iron apex seals or carbon racing apex
seals or Hurly
Engineering apex seals? What width? First I have heard of a flake
coming off.
How many races on that engine?
Paul Lamar
They are Mazda comp carbon one piece. They come a little long and you
have to file them down to the correct clearance They are 3MM I think. I
have been running the same three sets of seals since 1984. I was born in
42 and still get my toys out of trash cans. I have a set of ceramic seals
from the high dollar engine we destroyed, but they run two springs that
are very stiff. I think they seal well at 14,000 RPMs but we never go
there. It was a waste of money. If I was sure they would seal well at
9,000 and below I would run them with one spring. The brother seals in the
failed rotor had some pits in the sealing surface that would seem to
indicate a form of failure was on the way. I suppose I will have to break
down and buy some new parts before the year is out. It was not an engine
failure. It was a cheap old man using junk parts that killed the engine.
I was talking to Stan Lizauskas, (worked for Mandeville) who has engines
in some E production cars. These are 13Bs with big street ports and 38MM
venturies. He says he is getting 190 HP at the rear wheels. He is real big
on rotating mass. I noticed the spare rear end ring gear had been
lightened. What a job that must have been. Only the Honda is faster in
that class, and not by much. Lynn E Hanover
Jean Fouche wrote:
I just started the newly rebuilt 83 Cosmo/Luce 12A engine in my '75 Rx-2
also with carbon apex seals which I salvaged from an ex-race engine that had
a water o-ring failure. The apex seals and springs was still within spec, so
I thought a little experimentation is good. If Lynn has been using the same
carbon seals on his engine since 1984, I have a lot of hope for my engine.
Jean Fouche
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org