Subject: Cooling Systems & apex seal failure
From: ACRE NL
Date: 8/3/2001, 2:38 PM


<< > > > I run a 5/8" restrictor in the water outlet. I mix 10% antifreeze
and a bottle of Water Wetter. The problem was cracking the rotor housings
through a spark plug hole. The fix was to put small cuts int the water jacket
around the plugs in order to increase surface area. It is possible to have a
hot spot boiling away in one location and have normal water temps. I have
seen the problem in peripheral port housings but never on side port housings.
Anything that Carol Smith says is a good idea, is probably a good idea. His
books "Tune To Win" and "Prepare To Win" have great content on cooling
systems and aircraft fasteners. Also welding and aluminum and steel alloys.

Just lost one two weeks ago at the Nelson Ledges National race. We had
2nd place in the bag when a very tired apex seal lost a flake and the next
seal ran over it and broke into two pieces. This allowed the fire from the
first chamber to enter the second chamber 100 degrees too soon. The
preignition cleaned the teeth
off of the rotor gear. The rotor
stayed in index, and the driver drove it back to the pits with the 20
horse power he had left, to report a failed engine. The cast iron is OK. The
crank is OK. Today is trash day, so the rotor housing and rotor are gone. I
put it back together last night. Took less than three hours. I love these
things.         Lynn E. Hanover

Lynn, were those stock cast iron apex seals or carbon racing apex seals
or Hurly
Engineering apex seals? What width? First I have heard of a flake coming
off.
How many races on that engine?

Paul Lamar

They are Mazda comp carbon one piece. They come a little long and you have
to file them down to the correct clearance They are 3MM I think. I have been
running the same three sets of seals since 1984. I was born in 42 and still
get my toys out of trash cans. I have a set of ceramic seals from the high
dollar engine we destroyed, but they run two springs that are very stiff. I
think they seal well at 14,000 RPMs but we never go there. It was a waste of
money. If I was sure they would seal well at 9,000 and below I would run them
with one spring. The brother seals in the failed rotor had some pits in the
sealing surface that would seem to indicate a form of failure was on the way.
I suppose I will have to break down and buy some new parts before the year is
out. It was not an engine failure. It was a cheap old man using junk parts
that killed the engine.


I was talking to Stan Lizauskas, (worked for Mandeville) who has engines in
some E production cars. These are 13Bs with big street ports and 38MM
venturies. He says he is getting 190 HP at the rear wheels. He is real big on
rotating mass. I noticed the spare rear end ring gear had been lightened.
What a job that must have been. Only the Honda is faster in that class, and
not by much. Lynn E Hanover


Paul/Lynn
This is the first, I have heard of using dual springs under the Apex seals.
Is this common? Will this make an Apex seal less chance of sticking? What's
the pros and cons of using two versus one spring? Is there different spring
rates?
Rich Gillen
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org