Don Dunbar wrote:

Hi Paul,
Today I payed visit to the transmission rebuild shop where the owner is the expert on the American built auto trans.
On the bench where several Ford C6 transmission, he gave me a lesson on the diffence between most models.
The attached photo is a 4R100.
He is obtaining a price on these for me tonight and i will have them tomorrow.
Your dwg looks to have a shaft through the sun gear, where you going to srink fit this.
Regard Don

No attachment came through Don. Yep. Shrink fit and perhaps a bit of welding.
I figure if it slips it will weld itself. Also braze is good for this sort of
thing as there is lots of area to transmit the shear torque stress.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org