Don Dunbar wrote:

Hi Paul,
Today I payed visit to the transmission rebuild shop where the owner is

the expert on the American built auto trans.

On the bench where several Ford C6 transmission, he gave me a lesson on

the diffence between most models.

The attached photo is a 4R100.
He is obtaining a price on these for me tonight and i will have them

tomorrow.

Your dwg looks to have a shaft through the sun gear, where you going to

srink fit this.

Regard Don

No attachment came through Don. Yep. Shrink fit and perhaps a bit of

welding.

I figure if it slips it will weld itself. Also braze is good for this sort

of

thing as there is lots of area to transmit the shear torque stress.

Paul Lamar

Don Dunbar wrote:

Paul I have sent the photo of the pinion again
Regards Don

Yep. That looks exactly like the one Tracy is using.

BTW Don my wife says first or second week in November. How is the weather
then?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org