Jerry Hey wrote:
> >> Paul, here are two photos of my Griffin Rad with fan. The fan
>> produces a whopping 1800 cfm. It weighs six pounds. It is mounted
>> securely with brackets and bolts (no tie wraps). I like the thin
>> profile. Also, a picture of my water pump. I cut a section out of
>> the neck and rewelded. The result is 1.5 inches shorter. Jerry
Al Gietzen wrote:
Looks very restrictive to the air flow when the fans aren't running. And
the normal air flow would likely spin those fans all the time. Just a
consideration.
Al Gietzen
I think he plans to run them all the time Al. He may have no other
choice.
Paul Lamar
Al and Paul
According to the manufacturer of the fan "Flex-a-Lite", the fans are
not restrictive to normal flow when not running. In auto
installations, they are thermostatically controlled and switch on
only when needed, usually in stop and go situations. In normal
operations they would be off at high way speeds. I have no
intention of running the fans all of the time. Nice to have for
ground ops and climb outs on hot days. However, they do offer the
advantage of allowing the tailering of the inlets and outlets to the
high speed end of the spectrum. Much smaller than they would be
without the fans. --In reading though some of the NACA technical
papers on Boundary layers, in one experiment the boundary layer was
disrupted by stretching a strand of safety wire across the inlet
about 8 inches in front. Also, in one case they routed the air bleed
to provide "suction" at the inlet. Fascinating stuff. I have a lot
to learn. Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org