Monty Roberts wrote:

Hello all,

Here is the cooling concept that I have been working on for an EZ type

aircraft. This particular model is a Vari, but Herb has talked me out of
building a Vari. He suggests a Long EZ. This Idea will work for any canard.
The primary goals here are to minimize the base drag, and minimize cooling
drag. This is a problem with all of the canard designs. By reducing the
abrupt cross section change on the aft end of the fuselage, I hope to reduce
the base drag substantially. I also have done away with the large fairings
needed to clear the cylinders on an opposed 4 cyl aircraft engine. To
minimize cooling drag I have elected to use the conventional snorkel type
scoop, in order to get the maximum pressure recovery. The radiator will be
arranged in an oblique manner with a streamline diffuser as per Kucheman and
Webber. After the air passes through the radiator, it goes into an exhaust
driven ejector. This further heats and energizes the air. It then is passed
out the rear of the cra!

ft through a nozzle for maximum energy recovery. Cowl flaps will be used

to increase the exit area of the nozzle as needed. To reduce the drag of the
scoop further, I plan to take the engine intake air from the boundary bleed
area between the fuselage bottom and the top of the scoop. This is not shown
in this model. The P-51 had the cabin air intake in this area.

Note that this is only a rough conceptual model. I have made sure that

the engine, mount and radiator will fit. I did not spend much time making
sure that all the surfaces faired out true or all of the fillets were done
properly. This model was done in about 6 hours. The big advantage is now I
can play around with the placement of components etc.and refine the design
before I start to build. When I get the cowl like I like it, I will plot
some templates and cut them out of foam, then knock the edges down and glass
the cowl. Isn't 3D great!

Monty Roberts
RMI
1795 Berry St.
Fayetteville, AR 72701
tmrbrts@swbell.net

Don Dunbar wrote:

Hi Monty
Your cad model looks great, What program did you use to develop the model.
I posted some photos earlier in the week of my Cozy MK4 where I have done
the same. My next trick is to keep the 13B inside the confines of the cowl.
It all looks like it on Cad.
Regards Don

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org