Russell Kent wrote:
> > Paul responded:
Heck Ed could land a 747 on this.
I'm surprised at you, Paul. It isn't the *landing* you need to worry
about. The
question is: can Ed *takeoff* on that amount of "runway". I sincerely
hope so...
:-)
Russell Kent
You could always take it apart after the show and truck it out.
Paul Lamar
No! Paul, No! NO! NO! - Not after spending three days getting 72 bolts into
tight crooks and crannies while standing on my head - those wings stay ON!
{:>)
Regarding take off distance, I figure I could just keep driving around the
race track until I picked up enough speed - although some of the "S" turns
might get a bit hairy. I guess on those I could just hop from one part of
the "S" to the other in a straight line. If worst came to worst, I could
try "drafting" one of the race vehicles to get up enough speed for lift off.
The very last resort would be to put each of the main gears on roof of an
RX-7 and have them hit 80 mph before rotating. See, just gobs of ways to
get off.
In all seriousness, the back straight on the South course provides plenty of
takeoff room, so no problem there. But, thanks for mentioning it - people
have landed into areas they later found out they could not successfully take
off from.
Best Regards
Ed Anderson.
Greg claims he gets off in 400 feet with his turbo rotary Cozy.
It is hard to measure but Ken Welters rotary powered 2900 pound Coot with
nitrous oxide literally jumps up on the step and leaves the water
in just a few seconds despite my fat 230 pound butt in there:-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org