Ken Gillanders wrote:
pressure area. Chasing out the tension bolt holes with a 10mm x 1.25
instead
of 10mm x 1.0. OPPS!!! #$%^*#$!!! :o :( Picked up the wrong one out
of my
tap and dye box. I think the threads are toast. Probably a big paper
weight.
Any suggestions.
Ken Gillanders
Depressed in Fresno
Monty Roberts wrote:
Ken,
I don't know for sure how thick the casting is around the threads, but you
might try a Heli-Coil repair. You drill out a larger hole and then retap.
The helicoil looks like a metal spring. You thread this into the new hole
with a tang on the coil. Then you break off the tang. The ID is the same as
the original hole and threads. You can use lock tite as well. Not sure how
much I would trust this in an AC, but the race car guys use them.
Good luck,
Monty
Ken contact Mazdatrix. They may have some front housings they will part
with. Also try Dave Atkins or Hayes Rotary Engineering in Redmond Washington.
marc wiese wrote:
I also vote for the helicoils. In fact, helicoils are used as factory new
inserts in most aircraft spark plug holes and in other critical inserts in
aluminum. In fact I just used one on the 10mm exhaust stud in my FD engine!
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org