Subject: Book of the month turbo controllers
From: ACRE NL
Date: 8/6/2001, 2:43 PM


This is a great PIC micro book for anybody that would like
to dive into designing and building a computer
controlled turbo charger. Comes with the little
PC board shown and a bunch of software tools on
the included CD all for $50. The piece de resistance
to buying it for me was all the tools run on Linux as
well as Windoze.

Even mentions interfacing to a model airplane servo
which would be just the ticket for controlling the waste
gate. These servos have up to about 8 inch pounds
of torque which should be more than enough to control
the waste gate and cost about $55.

I am kind of reluctant to say this as Tracy is doing us
all a great service by providing us with low cost psru's and engine
control computers. I don't want to divert him from that
important service.

Tracy could modify his computer to control this servo with ease.
He is already monitoring things like absolute intake manifold pressure,
RPM and intake manifold temperature. The remaining parameters
would be EGT and turbine RPM to prevent destruction of the
turbo.

The servo works with pulse width modulation. The pulse varies
between one ms and two milliseconds and a pulse is needed
every 20 milliseconds.

The final controller would be far more sophisticated than
anything you can buy for a car or for a turbo aircraft engine
for that matter.

Paul Lamar


Peter Nunn wrote:

Hi paul,
If you are interested in a boost controller then I may be able to help.  I
have been using the PIC16C72 for an IVOPROP propellor speed govonor and am
looking for other products to develop.  I am currently finishing a retract
controller/sequencer using the PIC.  Can you describe the boost/throttle
position curve you would like, and is there someone who can test the
controller.  It would be fairly simple to provide an rs232 port and non
volatile memory to store a programmable boost curve but would probably add
to the cost.

are you interested?

regards

P.S. I don't yet have my web site set up for the Prop govonor yet, but check
my web site in about 3 weeks www.vistic-sw.com


You bet I am interested. You should be able to input absolute 
intake manifold limit, turbine RPM limit, intake manifold temp limits
and TIT limits.  Other than that keep the intake manifold 
absolute pressure constant. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org