Subject: Book of the month turbo controllers
From: ACRE NL
Date: 8/6/2001, 7:05 PM

Peter Nunn wrote:

Hmmm, No problems on the temps/pressure sensors, what if any is the turbine
speed sensor going to be?  Hall sensors are way to slow for the high speeds
of a turbine apart from the extreme temps.  Is there a sensor for this that
you know of?

I think it is possible to deduce this from the intake/exhaust pressure if
you know the following:

input abs pressure
Flow rate (from engine rpm)
output abs pressure
input air temp

Or is that making it too complex for the need?  The only problem with many
sensors is that if the controller is table driven the PIC would not have the
memory capacity.  However if these can be expressed as a simple formula then
we are in business.

If the above were possible then the following sensors would be required:

1. inlet air pressure
2. outlet air pressure
3. engine RPM
4. inlet air temp
5. EGT
6. TIT

Does the RWS ecu generate a serial data feed with 2, 3, 4  or would
duplicate sensors be needed. Probably not a major problem as all of the
sensors could be clustered around the turbocharger.

Are you turbocharging your aircraft and would you be interested in getting
this tested?

I had considered using Windows CE as the programmer as they now cost so
little and most have a serial port (my iPaq certainly has one).

Laser diode and photo diode for the compressor speed. Very fast.

Paul Lamar


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org