Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/6/2001, 10:27 PM


Finn Lassen wrote:

I removed my Ross drive after 160 hours. Sun gear is badly pitted
(galled?). Oddly enough only one of the 4 planet gears is similarly
pitted.

Sure sign of a non concentric sun gear. Machining error.

I also found a thin piece of steel in there. Too big to
have gotten in
there through the oil feed.

So far I've only removed the input shaft/sun gear. Need to
figure out
how to remove the planet carrier so I can look at the ring gear.

I'm sincerely disappointed. If anybody sees Chris Ross, tell him he
better hire a body guard.

I paid $3,000 for that piece of sh...!

I have no idea on how I can get this fixed. Replacing the
planet gears
is probably not a big deal, but the input shaft with the
sun gear? Then
there's adding a thrust bearing on the other side of the
input shaft. I
should probably toss the whole thing and get Tracy's.
Unfortunately, in
addition to the cost, that'll mean I'll have to move my
radiators a bit
as well as making a new oilcooler mount (hope it'll fit).

As a point of curiosity, how many more hours do you figure
I can get out
of the drive as is before it explodes?

Finn


Problem with the Ross as I suspected Finn. Good thing you took it
apart. Sell it to somebody with a machine shop that can fix it.

Paul Lamar


Hello Finn - How interesting. I also just had my Ross drive apart with 160
hours on it and found the same spalling of the sun gear. The planet gears
looked fine though. Mine is a 2.17:1 and the planet carrier came off with
some prying after removing four countersink bolts. The carrier is pinned to
the bell housing with dowel pins. I had mine apart because it started
leaking oil at the rear seal. I tried to reverse engineer the sun gear main
shaft, it looks like Ross must have welded the Ford sun gear to whatever
transmission input shaft he uses, and then machined the area as there is no
visible sign of welding. If that is what he did, the heat treatment of the
sun gear may have been affected, leading to the spalling. Just speculation.
The gear shaft is also pinned to the sun gear with I think a 5/16" dowel.
The hole in the shaft ended up very close to the rear oil seal and  I think
160 hours of wear caused the end play to build up to where the dowel hole
started to contact the oil seal. I installed a new oil seal and shimmed up
the end play and it is back on the plane, but I don't think I would feel
good about any more long cross countries the way it is. I put a magnet in
the oil drain so I can watch for metal particles. I need to get one of
Tracy's drives, at least I think he will be around to support it. You are
right, $3000/160 =$18.75 per hour for PSRU is kinda steep.

Chuck Dunlap

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Chuck-Dunlap-RossSunSpall.JPG