Subject: thermostats and racing pressure caps
From: ACRE NL
Date: 8/6/2001, 8:40 AM


<< Thanks for your comments, Lynn     Exactly where are the bypass holes
 > that you drilled?   Flying at near zero outside temperatures at
 > 10,000 ft  is not so unusual.  Because overheating is such a threat
 > in aircraft installations (small rads, small inlets and outlets,
 > tight plenums) we never worry about the engine  being too cool.
 > Anybody care to comment on the effects of operating below the
 > recommended temperatures?
 > Jerry Hey

 BTW Lynn, what pressure cap are you running?
  >>


The holes are drilled along the mounting flange. Oriented so the holes are
up. I plug the Mazda bypass hole in the water pump and run a real "American"
style thermostat. I have a 12 pound Stant lever cap on a RX-2 make up bottle.
The Engine builder says he would like us to be at 160 degrees max. This is
because we loose just under 5 HP for every 10 degrees above 160. I don't know
if there is more power below 160 or not but with 40 wt racing Red Line there
would be some losses running the oil under temp. He wants that at 160 max
also. That is more because of bearing cooling than a loss of power.  Lynn E.
Hanover.

I suspect Lynn you would be better off with a higher pressure cap
and less block restrictions to water flow. By all means install
a thermocouple down near the base of the spark plug to find out
for sure.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org